Cerwin-Vega CXA-8 Specifications download pdf (Page 5)

Cerwin-Vega! CXA-8 & CXA-10 AMPLIFIERS

Figure 1.2

1. Fan

This is a variable speed cooling fan. Cool air enters the ampliﬁer

through the fan ﬁlters located on the front of the ampliﬁer. Be

sure not to block these ports when installing the ampliﬁer or

other equipment.

2. Input connectors

Connect the input source to the unbalanced RCA connectors

using standard RCA cables.

3. Link connectors

These jacks are used to send a parallel signal to another device

or ampliﬁer.

4. High Pass Filter (HPF) switch.

These switches are used to acvate the built-in High Pass Filter.

The HPF rolls oﬀ signals below 40Hz. This improves bass per-

formance by liming sub-audio cone moon, making more

power available for the speaker’s rated frequency range. When

the ﬁlter is turned oﬀ, a 5 Hz roll oﬀ protects against DC or deep

sub-audio inputs.

5. Limiter switch

When the input signal connected to your ampliﬁer is too high,

you end up with a distorted output signal. To prevent this, both

channels feature a clip limiter that can be engaged or disen-

gaged selecvely.

6. Bridge / Stereo / Parallel switch

This switch changes the ampliﬁer operang mode between

stereo, mono bridged, and parallel.

7. 5-way Binding Post

Connect each channel of the unit to your speakers. Binding posts

are provided for each channel as so that paralleling of speakers

is possible. Connecon to the binding posts can be made with

bare wire, banana plugs, or spade lug terminaons. Make con-

necons to both the Channel 1 and Channel 2 terminals for

Stereo or Parallel Mode, or a single connecon across the red

terminals only of Channel 1 and Channel 2 for Bridged Mono

Mode.

8. Circuit breaker

The breaker acts in place of common disposable fuses. This cir-

cuit breaker will trip if there is a fault with the main voltage or

if maximum output is exceeded. Simply depress the circuit

breaker and power up the unit again.

9. AC input

IEC connector for AC power cable. Connect the supplied heavy-

gauge 3-pin IEC power cable.

CXA AMPLIFIER REAR PANEL DESCRIPTION

CXA Manual Rev 3_Manual_CXA_English_DB 1/31/2012 10:06 AM Page 3

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Cerwin-Vega CXA-8 Specifications Page 5

Comments to this Manuals

Related products and manuals for Audio amplifiers Cerwin-Vega CXA-8